|9-AB (Grey)||32g, 85g|
|11-AB (Red)||32g, 85g|
|12-AB (Black)||32g, 85g|
|13-AB (Clear)||32g, 85g|
|14-AB (White)||32g, 85g||144/CASE|
ABRO BP-675 provides a protective barrier to inhibit corrosion of battery terminals and cable connectors and prevents hard starts.
ABRO CL-100 can be used on all chains and for wire cable. This lubricant utilizes a specially developed formula designed for a combination of performance protection and endurance against wear and the elements.
ABRO EC-533 Electronic Contact Cleaner is a residual-free formulation that quickly dissolve sand removes oil, grease, flux, condensation and other contaminants from delicate electronic circuitry. EC-533 is safe to use on a wide variety of plastics and prevents degradation of electrical signals. ABRO EC-533 is ideal for use on:
ABRO SL-900 Silicone Spray Lubricant protects against moisture and corrosion, reduces wear on mechanical parts, repels moisture, and stops squeaking and sticking. ABRO SL-900 lubricates, seals, weatherproofs, and insulates. Use on items such as:
Shake can well before using. Surface to be treated should be clean, dry and free of dirt. Hold can upright about 10” (¼ m) from the area to be sprayed. Apply a thin, even coat. For a protective coating on metal surfaces, spray on and wipe off.
ABRO SS-510 Smoke Stop is an effective and easy to use additive to reduce smoke and quiet noisy engines. Just add the entire contents to the crankcase of an idling engine (Be careful to not overfill crankcase).
ABRO U-60 Spray Undercoat (New Formula!) is a rubberized undercoat to protect against rust, corrosion and moisture, and reduces road noise and vibrations. This rubberized, asphaltic formula composition resists chipping, abrasion, and exterior corrosion, so as to provide maximum protection and durability.
Surface to be undercoated must be clean, dry and free of any wax, rust or loose paint. Mask surrounding area from overspray. Shake well (at least 2 inutes after mixing ball is heard). Hold can upright 12”-18” from surface and apply uniform even strokes. After each 20-25 seconds of use, shake briefly again. Accidental overspray should be wiped off immediately
Warning: Because of extremely high operating temperatures, undercoating must not be applied within 12” of entire engine and exhaust system.